Combination 2 Person Traditional Stone Heater + Low EMF/ELF Infrared Sauna
Free Living Co APPROVED! This is your Low-Tox Sauna! Ships from Heavenly Heat!
GET 10% OFF by clicking this link 👇
Experience the best of both worlds with a 6kw Harvia traditional stone heater and our low EMF/ELF infrared heaters. Use the different heaters together or separately for the most customizable sauna experience on the market.
Current Lead Time: May
Only available in US
Buy yours today before it sells out again.
Free Shipping! Taxes included!
100% Non-Resinous Canadian Hemlock Wood.
No Glues, Plywood, or Stains.
Customizable Experience:
Use the Infrared heaters, Traditional Stone heater, or both at the same time! (The Infrared heaters will stop producing heat above 165F because using Infrared above that level is too hot)
Premium Warranty:
10 Years for wood/carpentry and 6 years for electrical components including heaters.
Industry Low Infrared EMF/ELF Levels:
We use grounded Low EMF/ELF heaters, faraday shielding. EMF below 2 mg and ELF below 7 v/m for Infrared Heaters.
8mm Tempered Glass:
Thick tempered glass provides phenomenal heat retention and an open, modern design.
Glass-Covered Chromotherapy Lighting:
Choose between 9 different light settings. Glass cover (no plastic).
Customizable Ventilation:
Our sauna vents can be opened or closed while sitting in the sauna. You can keep them closed to increase the heat-up speed and then open them to your liking during your sauna session.
Elevated Bench:
Even though our ventilation system is designed to move the hot air throughout the sauna, hot air still rises. Our elevated bench keeps you in the hottest part of the sauna.
Harvia KV-60-S or FLB-60-S, Stone Heater + Sauna Rocks:
We strictly use the Harvia KV-60-S or FLB-60-S because of performance and ease of use. Harvia is the most trusted name in Sauna Heaters.
Interior: 55.6 in. Width / 39.7 in. Depth / 71 in. Height
Weight: 485 pounds + traditional heater and rocks
Recommended two inch gap between the sauna and any walls or ceilings
Electrical:
Lights:
120V, plug into any standard outlet
Infrared Heaters:
120V
Dedicated 20 Amp
Standard US 20 Amp 3-prong plug
Traditional Heater:
240V
Dedicated 30 Amp
Electrician Required
Harvia KV-60-S or FLB-60-S (controls built on heater)
KV60 & FLB60 needs a 2 pole 30 amp non-GFCI breaker.
Run (2) #10 copper wires + ground to heater.
Wires connect to heater terminals 1 and 2.
Make sure to run the thermostat wire up the face of the sauna wall. Sensor mounts a foot down from the ceiling and about a foot away from the side of the heater.
2 Person Combination Sauna Assembly Manual
Choose options